Sheet Metal Attached to Lucite Panel



This is the underside view of an arrow with a
9 1/2 inch square piece of sheet metal attached
to a piece of lucite with spray adhesive and duct
tape. The lucite is 3/32 of an inch thick. This
piece will sit on top of the weather-stripping.
From the controller there will be 4 wires for UP,
DOWN, LEFT and RIGHT. Solder each of the wires
to the corner of the sheet metal panel, and cover
the soldered part with a few layers of duct tape.
When this arrow is stepped on, it will complete
the circuit with the sheet metal on the peg board,
and the weatherstripping will push it back up.
Remember to measure each blank space for the
arrows and cut the lucite pieces to fit underneath
the brackets. The lucite pieces should be a little
smaller than 11 inches square but they may not
be all the same size for each arrow.