|
materials were purchased at Home Depot, except
for the foam core from Wal-Mart and the Playstation
controller which I bought at FuncoLand.
| $34 - |
2' by 3' 26 gauge stainless steel (2 pieces)at Home Depot Note : I found 2' by 4' 26 gauge stainless steel at Lowes cheaper |
| $24 - | 16 Stanley brackets (8 packages - 2 brackets per package) |
| $22 - | 2' by 4' piece of Lucite 3/32 inch thick or .093 |
| $8 - | 1" by 2" MDF Fiberboard 6 foot length (4 pieces) |
| $3 - | 1" by 3" MDF Fiberboard 4 foot length (1 piece) |
| $8 - | 4' by 4' Peg Board 1/4 of an inch thick |
| $7 - |
|
| $7 - |
1-1/4 inch Phillips Mod Truss, Lath, Self Drill Screws 1 inch Black Drywall Phillips Screws |
| $6 - | 1/2 inch Plywood 2' by 3' |
| $6 - | Spray Adhesive and Duct Tape |
| $5 - | Telephone Wire and Solder |
| $2 - | Foam Core 3/16 of an inch thick |
| $3 - |
M-D High Density Foam Tape Weatherstrip 1/4 inch thick, 1/2 inch wide Closed-Cell Foam |
| $135 - | Estimated Total Cost of Building DDR Pad |
If you have any questions, post a message at DDRFreak.com